80 2.1.6_I LITHIUM METAL BATTERIES PACKED WITH EQUIPMENT (incl. lithium alloy batteries) Fully regulated batteries UN 3091 Applies to: Lithiummetal batteries packed with equipment with a lithiummetal content in excess of 2 g/battery “Equipment” means the device for which the lithium cells or batteries will provide electrical power for its operation. UN No., Proper Shipping Name UN 3091, LITHIUM METAL BATTERIES PACKED WITH EQUIPMENT Class 9 Packing Group Not assigned Hazard Label • Labels must be in the form of a square set at an angle of 45° (diamond-shaped) with minimum dimensions of 100 mm by 100 mm; except for air transport mode, labels dimensions may be reduced in the case of packages of such dimensions that they can only bear smaller labels. • They must have a line 5 mm inside the edge and running parallel with it. Prerequisite • Batteries must meet the General Requirements of § 1.3 in particular the test requirements Specific Requirements • Each battery incorporates a safety venting device or is designed to preclude a violent rupture under normal conditions of carriage; • Each battery is equipped with an effective means of preventing external short circuits Transport mode ADR IMDG IATA Passenger Aircraft Cargo Packing instructions P903 P903 PI 969 section I Batteries must be protected against short circuit, including protection against contact with conductive materials within the same packaging that could lead to a short circuit. Two possible solution, lithium metal batteries must: • be completely enclosed in inner packagings, then placed in a UN packaging of the type shown below that meets the Packing Group II performance standards, then placed with equipment in a strong, rigid outer packaging; or • be placed in inner packagings that completely enclose the batteries, then placed with equipment in a packaging that meets the Packing Group II performance standards of a type shown below. The equipment must be secured against movement within the outer packaging. Batteries must be packed: • in a rigid metal intermediate or • in a metal outer packaging Batteries must be surrounded by non-combustible and nonconductive cushioning material before being placed in the metal intermediate or metal outer packaging Packages not conforming to “Passenger Aircraft” requirements must be transported as “Cargo Aircraft Only” Packagings Drums (1A2, 1B2, 1N2, 1H2, 1D, 1G); Boxes (4A, 4B, 4N, 4C1, 4C2, 4D, 4F, 4G, 4H1, 4H2) Jerricans (3A2, 3B2, 3H2). Drums (1A2, 1B2, 1N2, 1H2, 1D, 1G); Boxes (4A, 4B, 4N, 4C1, 4C2, 4D, 4F, 4G, 4H2) Jerricans (3A2, 3B2, 3H2). Weight limit No limit No limit 5 kg Net 35 kg Net Tunnel code (E) - - - Transport cat. 2 - - - Exemptions chapter 1.1.3.6 limit ≤ 333 kg Net - - - Marking and Labelling of Packages UN 3091 UN 3091 LITHIUM METAL BATTERIES PACKED WITH EQUIPMENT UN 3091 LITHIUM METAL BATTERIES PACKED WITH EQUIPMENT Full Name ad Address of the shipper and the consignee Net weight (kg) Minimum dimensions: 120 × 110 mm Overpack OVERPACK + same labels as above OVERPACK + same labels as above OVERPACK + same labels as above OVERPACK + same labels as above Documents Transport document MDGF Shipper’s Declaration Copyright © www.batteriestransport.org
RkJQdWJsaXNoZXIy MjQwNg==